7705 SAR Interfaces
104
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
LAGs are supported on access ports on the following:
• 8-port Ethernet Adapter card, version 2
• 8-port Gigabit Ethernet Adapter card
• 10-port 1GigE/1-port 10GigE X-Adapter card (10-port GigE mode)
• 6-port Ethernet 10Gbps Adapter card
• 4-port SAR-H Fast Ethernet module
• 6-port SAR-M Ethernet module
• Packet Microwave Adapter card (for ports not in a microwave link)
• all fixed platforms
LAGs are supported on network ports on the following:
• 8-port Ethernet Adapter card, version 2
• 8-port Gigabit Ethernet Adapter card
• 10-port 1GigE/1-port 10GigE X-Adapter card
• 6-port Ethernet 10Gbps Adapter card
• 4-port SAR-H Fast Ethernet module
• 6-port SAR-M Ethernet module
• Packet Microwave Adapter card (for ports not in a microwave link and ports in a
1+0 network microwave link; LAGs are not supported on ports in a 1+1 HSB
microwave link)
• all fixed platforms
LAGs are supported on hybrid ports on the following:
• 8-port Gigabit Ethernet Adapter card
• 10-port 1GigE/1-port 10GigE X-Adapter card (10-port GigE mode)
• 6-port Ethernet 10Gbps Adapter card
• 6-port SAR-M Ethernet module
• Packet Microwave Adapter card (for ports not in a microwave link)
• all fixed platforms
On access ports, a LAG supports active/active and active/standby operation. For
active/standby operation the links must be in different subgroups. Links can be on
the same platform or adapter card/module or distributed over multiple components.
Load sharing is supported among the active links in a LAG group.
To Next Page
Loading...
