Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 383
3.13.2.10 DSL Commands
dsl
Syntax dsl
Context config>port
Description This command enables the context to configure DSL port attributes on an 8-port xDSL
module, a 6-port DSL Combination module, or an xDSL port on a 7705 SAR-Wx.
adsl2plus
Syntax adsl2plus {g992-5-a | g992-5-b}
no adsl2plus
Context config>port>dsl
Description This command configures a DSL port to support POTS or ISDN non-overlapped spectrum
over ADSL2+, in accordance with ITU G.992.5 Annex A and B. This command is supported
on the two xDSL ports on the 6-port DSL Combination module, on any port on the 8-port xDSL
module configured for xDSL, and on the xDSL port on the 7705 SAR-Wx.
Default g992-5-a
Parameters g992-5-a — configures the DSL port to support POTS non-overlapped spectrum over
ADSL2+ in accordance with ITU G.992.5 Annex A
g992-5-b — configures the DSL port to support ISDN non-overlapped spectrum over
ADSL2+ in accordance with ITU G.992.5 Annex B
atm-pvc
Syntax atm-pvc dsl-bonding-vpi dsl-bonding-vci
no atm-pvc
Context config>port>dsl
Description This command configures an ATM PVC for traffic on DSL lines in ADSL2 or ADSL2+ bonded
ATM mode.
Parameters dsl-bonding-vpi — specifies the VPI of the ATM PVC
Values 0 to 255
Default 8
To Next Page
Loading...
