Nokia 7705 SAR - 3.13.2.7 Microwave Link Commands

7705 SAR Interfaces
344
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
3.13.2.7 Microwave Link Commands
port
Syntax [no] port mw-link-id
Context config
Description This command configure a microwave link on a 7705 SAR-8 or 7705 SAR-18.
The no form of this command removes the microwave link configuration.
Parameters mw-link-id — specifies the microwave link ID number, using the form mw-link-id
Values id = 1 to 24
mw
Syntax mw
Context config>port
Description This command enables the context to configure microwave link parameters.
hold-time
Syntax [no] hold-time {[up hold-time-up] [down hold-time-down]}
Context config>port>mw
Description This command configures dampening timers on a microwave link. Dampening timers guard
against excessive link transitions reported to upper layer protocols.
The no form of this command removes the dampening timers configuration.
Default down 0 or up 0 — no microwave link dampening is enabled; link transitions are immediately
reported to upper layer protocols
Parameters hold-time-up — the number of seconds before an up-state to down-state transition is
reported to upper layer protocols
Values 0 to 900 s
hold-time-down — the number of seconds before a down-state to up-state transition is
reported to upper layer protocols
Values 0 to 900 s