Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 345
peer-discovery
Syntax [no] peer-discovery
Context config>port>mw
Description This command enables or disables peer discovery on the microwave link.
Peer discovery is used to discover the IP addresses of remote routers over the microwave
link, as well as the physical ports of the remote routers corresponding to the primary radios
for the microwave link.
Ports with peer discovery disabled do not send peer discovery packets and ignore any
received peer discovery packets. The CLI does not display the IP address of peers when peer
discovery is disabled.
protection
Syntax [no] protection
Context config>port>mw
Description This command enables protection switching on a microwave link.
The no form of this command removes the protection switching on a microwave link.
radio
Syntax radio port-id create [main | spare]
no radio port-id
Context config>port>mw
Description This command configures an MPR-e radio for a microwave link.
The no form of this command removes an MPR-e spare radio from the specified port
Parameters port-id — specifies a port on a Packet Microwave Adapter card on which an MPR-e radio
is configured, in the format slot/mda/port (port = 1 through 4)
Note: You cannot remove an MPR-e main radio that is associated with a microwave link.
The microwave link must be deleted and then re-configured with the desired MPR-e radio.
To Next Page
Loading...
