Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 303
3.13.1.21 E1 Commands
config
— [no] port {port-id | aps-group-id}
— tdm
— [no] e1 e1-id
— [no] channel-group channel-group-id
— atm
— cell-format cell-format
— min-vp-vpi value
— cisco-hdlc
— down-count down-count
—no down-count
— keepalive time-interval
—no keepalive
— up-count up-count
—no up-count
— crc {16 | 32}
— description description-string
—no description
— encap-type {atm | cem | ipcp | ppp-auto | frame-relay | hdlc |
cisco-hdlc}
—no encap-type
— frame-relay
— lmi-type
{ansi | itu | none | rev1}
— mode {dce | dte | bidir}
— n391dte intervals
—no n391dte
— n392dce threshold
—no n392dce
— n392dte threshold
—no n392dte
— n393dce count
—no n393dce
— n393dte count
—no n393dte
— t391dte keepalive
—no t391dte
— t392dce keepalive
—no t392dce
— idle-cycle-flag {flags | ones}
—no idle-cycle-flag
— idle-payload-fill {all-ones | pattern pattern}
—no idle-payload-fill
— idle-signal-fill {all-ones | pattern pattern}
—no idle-signal-fill
— mac ieee-address
—no mac
— mode
{access | network}
—no mode
— mtu mtu-bytes
—no mtu
— network