Nokia 7705 SAR - Page 479

Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 479
Description This command defines the data pattern to be transmitted (8-bit value) when the circuit
emulation service is not operational or temporarily experiences underrun conditions. This
command is only valid for CESoPSN services.
Default all-ones
Parameters all-ones — transmits 11111111
pattern — transmits the user-defined pattern
Values 0 to 255 (can be entered in decimal, binary, or hexadecimal format)
idle-signal-fill
Syntax idle-signal-fill {all-ones | pattern pattern}
no idle-signal-fill
Context config>port>tdm>ds1>channel-group
config>port>tdm>e1>channel-group
Description This command defines the signaling pattern to be transmitted (4-bit value) when the circuit
emulation service is not operational or temporarily experiences underrun conditions. This
command is only valid for CES with CAS.
Default all-ones
Parameters all-ones — transmits 1111
pattern — transmits the user-defined pattern
Values 0 to 15 (can be entered in decimal, binary, or hexadecimal format)
mac
Syntax mac ieee-address
no mac
Context config>port>tdm>ds1>channel-group
Note: See the 7705 SAR Services Guide for information on CESoPSN services.
Note: See the 7705 SAR Services Guide for information on CESoPSN services.