Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 441
3.13.2.20 Network Port Commands
network
Syntax network
Context config>port>dsl
config>port>ethernet
config>port>gpon
config>port>sonet-sdh>path
config>port>tdm>ds1>channel-group
config>port>tdm>ds3
config>port>tdm>e1>channel-group
config>port>tdm>e3
Description This command enables access to the context to configure network port parameters.
Default n/a
accounting-policy
Syntax accounting-policy policy-id
no accounting-policy
Context config>port>dsl>network
config>port>ethernet>network
config>port>gpon>network
config>port>sonet-sdh>path>network
config>port>tdm>ds1>channel-group>network
config>port>tdm>ds3>network
config>port>tdm>e1>channel-group>network
config>port>tdm>e3>network
Description This command configures an accounting policy that can apply to an interface.
An accounting policy must be configured before it can be associated to an interface. If the
accounting policy-id does not exist, an error is returned.
Accounting policies associated with service billing can only be applied to SAPs. Accounting
policies associated with network ports can only be associated with interfaces. Only one
accounting policy can be associated with an interface at a time.
No accounting policies are specified by default. You must explicitly specify a policy. If
configured, the accounting policy configured as the default under the
config>log>accounting-policy>default command is used.
To Next Page
Loading...
