Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 199
no shutdown
3.11.1.4 Configuring Adapter Card Fabric Statistics
The collection of fabric statistics can be enabled on an adapter card to report about
the fabric traffic flow and potential discards.
Fabric statistics do not apply to the Auxiliary Alarm card.
Use the following syntax to configure fabric statistics on an adapter card.
CLI Syntax: config>card>mda#
[no] fabric-stats-enabled
3.11.1.5 Configuring Adapter Card Fabric Profile
Ingress fabric profiles can be configured on an adapter card, in either a network or
access context, to allow network ingress to fabric shapers to be user-configurable at
rates that provide up to 1 Gb/s switching throughput from the adapter card towards
the fabric. For more information on fabric profiles, refer to the 7705 SAR Quality of
Service Guide, “QoS Fabric Profiles”.
Fabric profiles do not apply to the Auxiliary Alarm card.
Use the following CLI syntax to assign a fabric profile on an adapter card.
CLI Syntax: config>card>mda#
mda-type type
[no] fabric-stats-enabled
network
ingress
fabric-policy <fabric-policy-id>
queue-policy <name>
access
ingress
fabric-policy <fabric-policy-id>
no shutdown
To Next Page
Loading...
