Nokia 7705 SAR - 3.12 Service Management Tasks; 3.12.1 Changing a Provisioned Adapter Card Type

Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 281
3.12 Service Management Tasks
This section describes the following service management tasks:
• Changing a Provisioned Adapter Card Type
• Deleting an Adapter Card
3.12.1 Changing a Provisioned Adapter Card Type
To change an adapter card type already provisioned for a specific slot, you must shut
down any existing port configurations on the card, delete the adapter card
configuration, and provision the new adapter card.
Use the following CLI syntax to change an adapter card type:
CLI Syntax: port port-id
shutdown
exit
CLI Syntax: card slot-number //always 1
mda mda-number
shutdown
exit
no mda mda-number //deletes the adapter card
mda mda-number
mda-type mda-type //provisions new adapter card
no shutdown
The following CLI syntax shows an example of modifying an adapter card.
Example: config# port 1/1/1
config>port# shutdown
config>port# exit
config# port 1/1/2
config>port# shutdown
config>port# exit
config# card 1
config>card# mda 1
config>card>mda# shutdown
config>card>mda# exit
config>card# no mda 1
config>card# mda 1
config>card>mda# mda-type a16-chds1
config>card>mda# no shutdown