Nokia 7705 SAR - 3.11.2.17 Configuring Multilink ATM Inverse Multiplexing (IMA) Groups

7705 SAR Interfaces
262
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
The following CLI syntax shows an example of configuring LAG parameters:
Example: config# lag 2
config>lag# description LAG2
config>lag# port 1/4/3 priority 200 sub-group 1
config>lag# port 1/5/3 priority 100 sub-group 2
config>lag# lacp active administrative-key 32768
The following example displays a LAG configuration:
ALU-B>config>lag# info detail
----------------------------------------------
shutdown
description "LAG2"
port 1/4/3 priority 200 sub-group 1
port 1/5/3 priority 100 sub-group 2
lacp active administrative-key 32768
no mac
mode access
encap-type null
port-threshold 0
lacp-xmit-interval fast
lacp-xmit-stdby
no selection-criteria
no hold-time
standby-signaling lacp
----------------------------------------------
ALU-B>config>lag#
3.11.2.17 Configuring Multilink ATM Inverse Multiplexing (IMA)
Groups
IMA groups are supported on channelized 16-port T1/E1 ASAP Adapter cards,
32-port T1/E1 ASAP Adapter cards, 2-port OC3/STM1 Channelized Adapter cards,
and T1/E1 ports on the 7705 SAR-M (variants with T1/E1 ports). The groups
aggregate E1 or DS1 ATM channels into a single logical ATM interface.
3.11.2.17.1 Configuring IMA Groups
Use the following CLI syntax to configure IMA group parameters.
CLI Syntax: configure# port bundle-ima-slot/port.bundle-num
description description-string
multilink-bundle
ima
atm
cell-format {uni|nni}