Nokia 7705 SAR - 3.11.2.6 Configuring Voice Ports

7705 SAR Interfaces
240
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
3.11.2.6 Configuring Voice Ports
Use the following CLI syntax to configure an analog voice port on a 6-port E&M
Adapter card.
CLI Syntax: port port-id
voice
audio-wires {four-wires | two-wires}
[no] em
[no] channel-group channel-group-id
[no] description description-string
[no] encap-type cem
mode access
[no] shutdown
fault-signaling {idle | seized}
[no] idle-code abcd-code
[no] seized-code abcd-code
[no] loopback {internal-analog |
internal-digital}
signaling-lead
e {high | low | end-to-end}
m {high | low | end-to-end}
signaling-mode {em | transmission-only}
[no] shutdown
tlp-rx {-16.0 | -15.9 | ... | 6.9 | 7.0}
tlp-tx {-16.0 | -15.9 | ... | 6.9 | 7.0}
The following CLI syntax shows an example of configuring an analog voice port on a
6-port E&M Adapter card. The default values are used for the commands that are not
shown in the example.
Example: config# port 1/1/1
config>port# voice
config>port>voice# em
config>port>voice# em# channel-group 1
config>port>voice# em# channel-group# mode access
config>port>voice# em# channel-group# encap-type cem
config>port>voice# em# channel-group# no shutdown
config>port>voice# em# channel-group# exit
config>port>voice# em# signaling-lead
config>port>voice# em# signaling-lead# e high
config>port>voice# em# signaling-lead# exit
config>port>voice# em# signaling-mode
config>port>voice# em# signaling-mode# em
config>port>voice# em# signaling-mode# exit
config>port>voice# em# no shutdown
config>port>voice# em# exit
config>port>voice# exit