Nokia 7705 SAR - Page 241

Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 241
config>port# no shutdown
config>port# exit
config#
Use the following CLI syntax to configure an analog voice port on an 8-port Voice &
Teleprotection card.
CLI Syntax: port port-id
voice
fxo
channel-group channel-group-id
description description-string
encap-type {cem}
mode access
no shutdown
fault-signaling {idle | seized}
loopback {internal-digital}
no shutdown
fxs
channel-group channel-group-id
description description-string
encap-type cem
mode access
no shutdown
fault-signaling {idle | seized}
loopback {internal-digital}
ring-generation {16 | 20 | 25}
no shutdown
line-balance {nominal | 800 | short | long}
signaling-type {3600plar | 1511plar | 3600ls |
1511profile1 | 3600re}
tlp-rx decibels {-7.0 | -6.9 | ... | -0.1 | 0.0}
tlp-tx decibels {-4.0 | -3.9 | ... | 2.9 | 3.0}
The following CLI syntax shows an example of configuring an analog voice port on
an 8-port Voice & Teleprotection card. The default values are used for the commands
that are not shown in the example.
Example: config# port 1/1/6
config>port# voice
config>port>voice# fxo
config>port>voice>fxo# channel-group 1
config>port>voice>fxo>channel-group# mode access
config>port>voice>fxo>channel-group# encap-type cem
config>port>voice>fxo>channel-group# no shutdown
config>port>voice>fxo>channel-group# exit
config>port>voice>fxo# no shutdown
config>port>voice>fxo# exit