Nokia 7705 SAR - 3.11.2.7 Configuring Teleprotection Ports

7705 SAR Interfaces
244
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
3.11.2.7 Configuring Teleprotection Ports
Use the following CLI syntax to configure a teleprotection port on an 8-port Voice &
Teleprotection card.
CLI Syntax: port port-id
tdm
codir
channel-group channel-group-id
description description-string
encap-type cem
mode access
no shutdown
loopback {internal | line}
report-alarm {ais | los}
no shutdown
tpif
channel-group channel-group-id
description description-string
encap-type cem
mode access
no shutdown
timeslots timeslots
loopback {internal | line}
report-alarm {los | rai}
no shutdown
The following CLI syntax shows an example of configuring a teleprotection port on
an 8-port Voice & Teleprotection card. The default values are used for the commands
that are not shown in the example.
Example: config# port 1/1/3
config>port# tdm
config>port>tdm>codir
config>port>tdm>codir# channel-group 1
config>port>tdm>codir>channel-group# mode access
config>port>tdm>codir>channel-group# encap-type cem
config>port>tdm>codir>channel-group# no shutdown
config>port>tdm>codir>channel-group# exit
config>port>tdm>codir>no shutdown
config>port>tdm>codir# exit
config>port>tdm# exit
config>port# no shutdown
config>port# exit
config#