7705 SAR Interfaces
386
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
3.13.2.12 GNSS Commands
gnss
Syntax gnss
Context config>port
Description This command enters the context to perform GNSS receiver port configuration.
Default n/a
antenna-cable-delay
Syntax antenna-cable-delay 0 .. 32767
no antenna-cable-delay
Context config>port>gnss
Description This command configures the expected signal delay resulting from the length of the antenna
cable.
The no form of this command returns the value to the default.
Default 0
Parameters 0 .. 32767 — the signal delay, in nanoseconds
elevation-mask-angle
Syntax elevation-mask-angle 0 .. 89
no elevation-mask-angle
Context config>port>gnss
Description This command configures the elevation mask angle. It provides a method of filtering satellites
to be used by the system.
Configuring an elevation mask angle below 10° is not recommended.
The no form of this command returns the value to the default.
Default 10
Parameters 0 .. 89 — the elevation mask angle, in degrees.
To Next Page
Loading...
