Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 195
3.11.1 Configuring Cards and Adapter Cards
This section contains the following topics:
• Configuring Cards
• Configuring Adapter Card Network Queue QoS Policies
• Configuring Ring Adapter Card or Module Network and Network Queue QoS
Policies
• Configuring Adapter Card Fabric Statistics
• Configuring Adapter Card Fabric Profile
• Configuring Adapter Card Clock Mode
• Configuring Adapter Card Voice Attributes
• Configuring Ring Adapter Card or Module Parameters
• Configuring Auxiliary Alarm Card, Chassis, and Ethernet Port External Alarm
Parameters
• Displaying Adapter Card Information
3.11.1.1 Configuring Cards
Card configurations must include a chassis slot designation. A slot must be
preconfigured with the type of card and adapter cards that are allowed to be
provisioned.
The mda-mode command is used on the following adapter cards to configure the
appropriate encapsulation methods (cem-atm-ppp or cem-fr-hdlc-ppp) that are
required to support pseudowire services:
• 4-port DS3/E3 Adapter card
• 16-port T1/E1 ASAP Adapter card, version 2
• 32-port T1/E1 ASAP Adapter card
The mda-mode command is used on the 10-port 1GigE/1-port 10GigE X-Adapter
card to configure the card for either 10-port 1GigE mode or 1-port 10GigE mode
(x10-1gb-sfp or x1-10gb-sf+).
The mda-mode command is used on the 4-port OC3/STM1 / 1-port OC12/STM4
Adapter card to configure the card for either 4-port OC3/STM1 mode or 1-port
OC12/STM4 mode (p4-oc3 or p1-oc12).
To Next Page
Loading...
