Nokia 7705 SAR - 3.11.2.22 Configuring GNSS Receiver Port Parameters

7705 SAR Interfaces
276
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
speed
{1200|2400|4800|9600|19200|38400|56000
|64k|128k|256k|384k|512k|640k|768k|89k
|1024k|1152k|1280k|1408k|1536k|1664k
|1792k|1920k}
no shutdown
exit
no shutdown
exit
exit
no shutdown
Use the config port info command to display the new port configuration information:
*A:ALU-A>config>port# info
----------------------------------------------
description "RS-232/V.35/X.21"
serial
x21
speed 1024k
channel-group 1
shutdown
description "DS0GRP"
mode access
encap-type cisco-hdlc
cisco-hdlc
keepalive 10
up-count 1
down-count 3
exit
exit
no shutdown
exit
exit
no shutdown
----------------------------------------------
*A:ALU-A>config>port#
3.11.2.22 Configuring GNSS Receiver Port Parameters
Use the following CLI syntax to configure GNSS receiver port parameters.
CLI Syntax: config# port port-id
gnss
antenna-cable-delay 0..32767
no antenna-cable-delay
elevation-mask-angle 0..89
no elevation-mask-angle
[no] type [gps] [glonass]