Nokia 7705 SAR - Page 275

Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 275
Use the config port info command to display the new port configuration information:
*A:ALU-A>config>port# info detail
----------------------------------------------
description "DS1/E1"
tdm
e1
shutdown
framing g704
no loopback
clock-source node-timed
no signal-mode
report-alarm ais los
no report-alarm oof rai looped ber-sd ber-sf
no hold-time
ssm
shutdown
ssm-bit 8
no tx-dus
channel-group 1
description "DS0GRP"
mode access
encap-type cisco-hdlc
no mtu
timeslots 2-32
crc 16
idle-cycle-flag flags
no scramble
cisco-hdlc
keepalive 0
upcount 1
downcount 3
exit
no shutdown
exit
no shutdown
exit
line-impedance 120
exit
no shutdown
----------------------------------------------
*A:ALU-A>config>port#
Use the following CLI syntax to configure an X.21 serial port (at super-rate speeds)
on a 12-port Serial Data Interface card for cHDLC. The syntax for a V.35 serial port
is similar.
CLI Syntax: port port-id
serial
x21
channel-group channel-group-id
encap-type {cem | ipcp | frame-relay
| hdlc | cisco-hdlc}
mode access
no shutdown