Nokia 7705 SAR - 3.13.1.8 DSL Commands

Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 289
— ptp-asymmetry ptp-asymmetry
—no ptp-asymmetry
— qinq-etype 0x0600 to 0xffff
— report-alarm [signal-fail] [remote] [local] [no-frame-lock] [high-ber]
—no report-alarm
— speed {10 | 100 | 1000 | 10000}
— ssm
— code-type {sonet | sdh}
— [no] shutdown
— [no] tx-dus
— [no] vlan-filter filter-id
— xgig {lan | wan}
— xor-mode {rj45 | rjp5 | sfp}
3.13.1.8 DSL Commands
config
— [no] port port-id
— dsl
— adsl2plus {g992-5-a | g992-5-b}
—no adsl2plus
— atm-pvc dsl-bonding-vpi dsl-bonding-vci
—no atm-pvc
— cfm-loopback priority {low | high}
—no cfm-loopback
— dot1q-etype 0x0600 to 0xffff
—no dot1q-etype
— down-when-looped
— keep-alive timer
— [no] keep-alive
— retry-timeout timer
— [no] retry-timeout
— [no] shutdown
— [no] use-broadcast-address
— efm-oam
— [no] accept-remote-loopback
— hold-time time-value
—no hold-time
— mode {active | passive
}
— [no] shutdown
— [no] transmit-interval interval [multiplier multiplier]
— [no] tunneling
— egress-rate sub-rate
—no egress-rate
— encap-type {dot1q | null | qinq}
Note: For more information about how to configure the scheduler mode on Ethernet ports,
refer to the 7705 SAR Quality of Service Guide.