Nokia 7705 SAR - Page 288

7705 SAR Interfaces
288
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
—no retry-timeout
— [no] shutdown
— [no] use-broadcast-address
— duplex {full | half}
— efm-oam
— [no] accept-remote-loopback
— hold-time time-value
—no hold-time
— mode {active | passive}
— [no] shutdown
— [no] transmit-interval interval [multiplier multiplier]
— [no] tunneling
— egress-rate sub-rate [include-fcs] [allow-eth-bn-rate-changes] [hold-time
hold-time]
—no egress-rate
— encap-type {dot1q | null | qinq}
—no encap-type
— [no
] group-encryption
— encryption-keygroup keygroup-id direction {inbound | outbound}
—no encryption-keygroup direction {inbound | outbound}
— hold-time {[up hold-time-up] [down hold-time-down]}
—no hold-time
— ingress-rate ingress-rate cbs {size [bytes | kilobytes] | default}
—no ingress-rate
— src-pause
—no src-pause
— lacp-tunnel
—no lacp-tunnel
— lldp
— loopback {line | internal} {timer {0 | 30 .. 86400} | persistent} [swap-src-dst-
mac]
—no loopback
— mac ieee-address
—no mac
—
mode {access | network | hybrid}
—no mode
— mtu mtu-bytes
—no mtu
— network
— accounting-policy policy-id
— [no] accounting-policy
— [no] collect-stats
— egress
— shaper-policy name
—no shaper-policy
— unshaped-if-cir cir-rate
—no unshaped-if-cir
— queue-policy name
—no queue-policy
— scheduler-mode {profile | 4-priority | 16-priority}(See Note below)
— phy-tx-clock {auto-pref-master | auto-pref-slave | slave | master}
—no phy-tx-clock
— poe [plus]
—no poe