7705 SAR Interfaces
444
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
On Gen-3 hardware, the cir-rate for this command can be configured and is applied but has
no effect on the network port, except for network traffic in hybrid mode, where the cir-rate
value has an effect.
On the 8-port Ethernet Adapter card, version 2, shaped and unshaped VLANs are arbitrated
towards the port but the egress-rate cannot be enabled.
The no form of the command sets the unshaped-if-cir CIR rate to 0 kb/s.
Default no unshaped-if-cir
Parameters cir-rate — the CIR rate for the aggregate of all the unshaped VLANs on the port
Values 0 to 10000000 kb/s, or max
Default 0 kb/s
queue-policy
Syntax queue-policy name
no queue-policy
Context config>port>dsl>network
config>port>ethernet>network
config>port>gpon>network
config>port>sonet-sdh>path>network
config>port>tdm>ds1>channel-group>network
config>port>tdm>ds3>network
config>port>tdm>e1>channel-group>network
config>port>tdm>e3>network
Description This command specifies the network queue policy that defines queue parameters such as
CBS-priority-only burst size, MBS, CIR, and PIR rates, as well as FC-to-queue mappings.
The network queue policy is defined in the config>qos>network-queue context. Refer to the
7705 SAR Quality of Service Guide, “Network Queue QoS Policies”, for more information.
The no form of this command reverts to the default.
Default “default”
Parameters name — specifies an existing network queue policy name
scheduler-mode
Syntax scheduler-mode {profile | 4-priority | 16-priority}
Context config>port>ethernet>network
Description This command selects the network-side scheduling option for the following:
To Next Page
Loading...
