Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 393
3.13.2.14 LLDP Ethernet Port Commands
Refer to the 7705 SAR Basic System Configuration Guide, “System Management”,
for LLDP system commands.
lldp
Syntax lldp
Context config>port>ethernet
Description This command enables the context to configure LLDP parameters on the specified port.
dest-mac
Syntax dest-mac {nearest-bridge | nearest-non-tpmr | nearest-customer}
Context config>port>ethernet>lldp
Description This command configures destination MAC address parameters.
Parameters nearest-bridge — configures the LLDP to use the nearest bridge
nearest-non-tpmr — configures the LLDP to use the nearest non-two-port MAC relay
(TPMR) bridge
nearest-customer — configures the LLDP to use the nearest customer bridge
admin-status
Syntax admin-status {rx | tx | tx-rx | disabled}
Context config>port>ethernet>lldp>dest-mac
Description This command specifies the administratively desired status of the local LLDP agent.
Default disabled
Parameters rx — specifies that the LLDP agent will receive, but will not transmit, LLDP frames on
this port
tx — specifies that the LLDP agent will transmit LLDP frames on this port and will not
store any information about the remote systems connected to it
Note: In order for LLDP to be operational on the Ethernet ports on the 2-port 10GigE
(Ethernet) Adapter card/module, the v-port must be active (that is, in no shutdown mode).
To Next Page
Loading...
