Nokia 7705 SAR - 3.11.2.5 Configuring SONET;SDH Port Parameters

7705 SAR Interfaces
232
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
When a port is configured for access mode, the appropriate encapsulation type can
be specified to distinguish the services on the port. Once a port has been configured
for access mode, multiple services may be configured on the port.
QinQ encapsulation type is supported on the DSL block on the 7705 SAR-Wx.
However, it is not supported on the DSL Module on the 7705 SAR-M.
Use the following CLI syntax to configure a DSL port for access mode.
CLI Syntax: port port-id
dsl
mode access
encap-type {dot1q | null | qinq}
The following CLI syntax shows an example of configuring a DSL port for access
mode.
Example: config# port 1/3/1
config>port# description "DSL access port"
config>port# dsl
config>port>dsl# mode access
config>port>dsl# encap-type dot1q
config>port>dsl# exit
config>port# no shutdown
Use the config port info command to display port configuration information.
ALU-A>config>port>dsl# info
----------------------------------------------
description "DSL access port"
dsl
mode access
encap-type dot1q
exit
no shutdown
----------------------------------------------
ALU-A>config>port#
3.11.2.5 Configuring SONET/SDH Port Parameters
Use the following CLI syntax to configure SONET/SDH port parameters on a 4-port
OC3/STM1 Clear Channel Adapter card.
CLI Syntax: [no] port port-id
sonet-sdh
clock-source {loop-timed | node-timed}
framing {sonet | sdh}