Nokia 7705 SAR - 3.13.1.20 DS3 Commands

Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 301
— [no] signal-mode cas
— [no] shutdown
— timeslots timeslots
—no timeslots
— clock-source {loop-timed | node-timed | adaptive | differential}
— framing (DS1) {esf | sf | ds1-unframed}
— hold-time {[up hold-time-up] [down hold-time-down]}
—no hold-time
— loopback (DS1) {line | internal | fdl-ansi | fdl-bellcore | payload-ansi}
—no loopback (DS1)
— [no] remote-loop-respond
— [no] report-alarm {ais | los | oof | rai | looped | ber-sd | ber-sf}
—
[no] signal-mode cas
— [no] shutdown
— threshold {ber-sd | ber-sf} rate threshold-rate
—no threshold {ber-sd | ber-sf}
3.13.1.20 DS3 Commands
config
— [no] port {port-id | aps-group-id}
— tdm
— [no] ds3 [sonet-sdh-index]
— atm
— cell-format cell-format
—no cell-format
— mapping direct
—no mapping
— min-vp-vpi value
—no min-vp-vpi
— channelized {ds1 | e1}
—no channelized
— clock-source {loop-timed | node-timed | differential | free-run}
— crc {16 | 32}
— description description-string
—no description
— encap-type {atm | ppp-auto | frame-relay}
—no encap-type
— [no] feac-loop-respond
— frame-relay
— lmi-type {ansi | itu | none | rev1}
— mode {dce | dte | bidir}
— n391dte intervals
—no n391dte
— n392dce threshold
—no n392dce
— n392dte threshold
—no n392dte
— n393dce count
—no n393dce
— n393dte count