Nokia 7705 SAR - Page 512

7705 SAR Interfaces
512
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
Parameters intervals — sets the number of exchanges to be done before requesting a full-status
report. A value of 1 specifies to receive full-status messages only.
Values 1 to 255
n392dce
Syntax n392dce threshold
no n392dce
Context config>port>tdm>ds1>channel-group>frame-relay
config>port>tdm>ds3>frame-relay
config>port>tdm>e1>channel-group>frame-relay
config>port>tdm>e3>frame-relay
config>port>serial>v35>channel-group>frame-relay
config>port>serial>x21>channel-group>frame-relay
Description This command configures the DCE error threshold for the frame relay LMI. The threshold
specifies the number of errors needed to bring down a link.
The no form of this command returns the n392dce counter to the default value.
Default 3
Parameters threshold — sets the number of errors that will put the channel in an operationally down
state
Values 1 to 10
n392dte
Syntax n392dte threshold
no n392dte
Context config>port>tdm>ds1>channel-group>frame-relay
config>port>tdm>ds3>frame-relay
config>port>tdm>e1>channel-group>frame-relay
config>port>tdm>e3>frame-relay
config>port>serial>v35>channel-group>frame-relay
config>port>serial>x21>channel-group>frame-relay
Description This command configures the DTE error threshold for the frame relay LMI. The threshold
specifies the number of errors needed to bring down a link.
The no form of this command returns the n392dte counter to the default value.
Default 3