Nokia 7705 SAR - 3.13.1.25 SCADA Commands

Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 307
—no encap-type
— hold-time down hold-down-time
—no hold-time
— lacp [mode] [administrative-key admin-key]
—no lacp
— lacp-xmit-interval {slow | fast}
—no lacp-xmit-interval
— [no] lacp-xmit-stdby
— mac ieee-address
—no mac
— mode {access | network | hybrid}
—no mode
— port port-id [port-id] [priority priority] [sub-group sub-group-id]
—no port port-id
— port-threshold value [action {dynamic-cost | down}]
—no port-threshold
— selection-criteria [best-port | highest-count | highest-weight]
[slave-to-partner]
[subgroup-hold-time hold-time]
—no selection-criteria
— [no] shutdown
— standby-signaling [lacp | power-off]
—no standby-signaling
3.13.1.25 SCADA Commands
config
— scada bridge-id
— [no] branch branch-id
— description description-string
—no description
— gain
— input decibels
— output decibels
— [no] sidetone (see Note:)
— [no] shutdown
— [no] squelch
— description description-string
—no description
— mddb
— force-active master branch-id
— redundant-mode redundant-mode
— [no] report-alarm [hcmOof] [hcmRai]
— speed {600 | 1200 | 2400 | 4800 | 9600 | 19200 | 38400 | 56000}
— squelch timeout
timeout
— squelch reset
—no squelch
— squelch-recovery [mode] [time time]
— pcm
— force-active master branch-id
— redundant-mode redundant-mode
— squelch timeout timeout