7705 SAR Interfaces
518
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
input
Syntax input decibels
Context config>scada>branch>gain
Description This command sets the input gain for the branch. The input gain defines the magnitude of the
increase or decrease of the signal transmitted into the bridge.
Default 0
Parameters decibels — number of decibels by which the transmitted signal is increased or decreased
Values –16 to +9 dB (in 1-dB increments)
output
Syntax output decibels
Context config>scada>branch>gain
Description This command sets the output gain for the branch. The output gain defines the magnitude of
the increase or decrease of the signal received from the bridge.
Default 0
Parameters decibels — number of decibels by which the received signal is increased or decreased
Values –16 to +9 dB (in 1-dB increments)
squelch
Syntax [no] squelch
Context config>scada>branch
Description This command administratively enables the squelching function for the branch. The
squelching function can only be enabled on a branch if it is enabled at the bridge level
(config>scada>mddb>squelch or config>scada>pcm>squelch).
The no form of this command administratively disables the squelching function on the branch.
The command does not apply to the VCB application.
Default squelch (slave branches)
no squelch (master branches)
To Next Page
Loading...
