Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 351
3.13.2.9 Ethernet Commands
ethernet
Syntax ethernet
Context config>port
Description This command enables access to the context to configure Ethernet port attributes on all
cards, modules, and chassis that support Ethernet. For the Packet Microwave Adapter card,
this command does not apply to ports that support microwave awareness.
access
Syntax access
Context config>port>ethernet
Description This command enables access to the context to configure access mode parameters.
egress
Syntax egress
Context config>port>ethernet>access
Description This command enables access to the context to configure the CIR rate for the aggregate of
all the unshaped 4-priority SAPs on the port and to configure the shaper policy.
shaper-policy
Syntax shaper-policy name
no shaper-policy
Context config>port>ethernet>access>egress
Description This command assigns a shaper policy to the specified hybrid port.
For hybrid ports, the shaper policy is independently assigned to access or network egress
traffic. When the Ethernet port mode is changed to hybrid mode, the default policy is assigned
to access and network traffic. To change an access or network policy, use the commands
config>port>ethernet> access>egress>shaper-policy and
config>port>ethernet>network>egress>shaper-policy.
To Next Page
Loading...
