7705 SAR Interfaces
42
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
The 6-port DSL Combination module has six RJ-11 ports on its faceplate. Four of the
RJ-11 ports support G.SHDSL.bis pairs, and two RJ-11 ports support xDSL
operating in ADSL2,ADSL2+, or VDSL2 mode with no intermixing of DSL types.
The 8-port xDSL module has eight RJ-11 ports on its faceplate that support ADSL2,
ADSL2+, or VDSL2 mode with no intermixing of DSL types.
The 7705 SAR-M views the Ethernet link on a DSL module as an Ethernet port. Any
services on the 7705 SAR that are supported on an Ethernet port are also supported
on the Ethernet link on a DSL module.
Two variants of the 7705 SAR-Wx support one 4-pair xDSL port.
3.1.3.4 GNSS Receiver
The 7705 SAR-H GPS Receiver module is equipped with a GPS RF port for retrieval
and recovery of GPS and GLONASS signals. The 7705 SAR-Ax and some variants
of the 7705 SAR-Wx are equipped with an integrated GNSS receiver and a GNSS
RF port for retrieval and recovery of GPS and GLONASS signals.
The GNSS Receiver card installed in the 7705 SAR-8 or 7705 SAR-18 is equipped
with a GNSS RF port for retrieval and recovery of both GPS and GLONASS signals.
3.1.3.5 GPON
The GPON module is a single-port optical network terminal (ONT) that integrates
passive optical network (PON) capabilities into the 7705 SAR-M. The GPON module
serves as an Ethernet Layer 2 connection point for receiving data from and
transmitting data into a GPON network.
The GPON module connects to the 7705 SAR-M as a Gigabit Ethernet port. From an
operational perspective, the 7705 SAR-M views the module as one of its Ethernet
ports.
Note: GLONASS-only signal recovery is not supported in this release.
To Next Page
Loading...
