Nokia 7705 SAR - 3.1.3.12 Access, Network, and Hybrid Ports

7705 SAR Interfaces
54
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
For a 7705 SAR-Wx Ethernet with xDSL variant:
*A:ALU-1# show card state
==============================================================================
Card State
==============================================================================
Slot/ Provisioned Type Admin Operational Num Num Comments
Id Equipped Type (if different) State State Ports MDA
------------------------------------------------------------------------------
1 iom-sar up up 2
1/1 i4-1gb-b up up 4
1/2 i4-xdsl up up 1
A csm-2.5g up up Active
==============================================================================
*A:ALU-1#
For a 7705 SAR-X:
*A:ALU-1# show card state
==============================================================================
Card State
==============================================================================
Slot/ Provisioned Type Admin Operational Num Num Comments
Id Equipped Type (if different) State State Ports MDA
------------------------------------------------------------------------------
1 iom-sar up up 3
1/1 i8-chds1-x up up 8
1/2 i7-mix-eth up up 7
1/3 i7-mix-eth up up 7
A csm-2.5g up up Active
===============================================================================
*A:ALU-1#
3.1.3.12 Access, Network, and Hybrid Ports
All ports must be set to access (customer-facing), network, or hybrid mode. When
the mode is configured on a port, the appropriate encapsulation type must be
configured to distinguish the services on the port or channel (for access mode), or to
define the transport mode (for network mode).
For the 16-port T1/E1 ASAP Adapter card, version 2, 32-port T1/E1 ASAP Adapter
card, and 4-port DS3/E3 Adapter card, the card must be enabled to support a set of
software services before the encapsulation type is configured. This support is
enabled using the mda-mode command (see the mda-mode command in the
Configuration Command Reference section):
• access ports — configured for customer-facing traffic on which services are
configured. If a Service Access Point (SAP) is to be configured on the port or
channel, the port or channel must be configured as an access port or channel.