7705 SAR Interfaces
318
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
mda-mode
Syntax mda-mode mda-mode
no mda-mode
Context config>card>mda
Description This command configures the set of software services that are enabled for a specific adapter
card.
The cem-atm-ppp and cem-fr-hdlc-ppp parameter values are used to configure the
appropriate encapsulation methods that are required to support pseudowire services. These
values apply to the following adapter cards:
• 16-port T1/E1 ASAP Adapter card, version 2
• 32-port T1/E1 ASAP Adapter card
• 4-port DS3/E3 Adapter card
The card-level encapsulation capabilities must be configured before the encap-type
parameter is configured at the port level.
The x10-1gb-sfp and x1-10gb-sf+ parameter values are used for the 10-port 1GigE/1-port
10GigE X-Adapter card to define whether the card operates in 10-port 1GigE mode or 1-port
10GigE mode.
The p4-oc3 and p1-oc12 parameter values are used for the 4-port OC3/STM1 / 1-port
OC12/STM4 Adapter card to define whether the card operates in 4-port OC3/STM1 mode or
1-port OC12/STM4 mode.
The mddb, pcm, and vcb parameter values are used for the Integrated Services card to
define which SCADA application is active on the card.
The no form of this command sets the mda-mode back to the card’s default mode. All service
and port/channel configurations associated with the adapter card must be removed before
the mda-mode can be changed. On the 4-port OC3/STM1 / 1-port OC12/STM4 Adapter card,
changing the mode causes the adapter card to reset.
Default x1-10gb-sf+ (for the 10-port 1GigE/1-port 10GigE X-Adapter card)
cem-atm-ppp (for the T1/E1 ASAP adapter cards and 4-port DS3/E3 Adapter card)
p4-oc3 (for the 4-port OC3/STM1 / 1-port OC12/STM4 Adapter card)
mddb (for the Integrated Services card)
Parameters mda-mode — the encapsulation mode for the adapter card to be provisioned
Values cem-atm-ppp
cem-fr-hdlc-ppp
x10-1gb-sfp
x1-10gb-sf+
To Next Page
Loading...
