Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 517
3.13.2.32 SCADA Commands
scada
Syntax scada bridge-id
Context config
Description This command configures a SCADA bridge on the Integrated Services card.
Parameters bridge-id — specifies a SCADA bridge, in the format slot/mda/bridge-id where bridge-id
is 1 to 16
branch
Syntax [no] branch branch-id
Context config>scada
Description This command configures a branch that is used by the configured bridge.
The no form of the command deletes the specified branch.
Parameters branch-id — the branch identifier
Values 1 to 32; branches 1 and 2 are dedicated as master branches, and
branches 3 to 32 are slave branches (MDDB)
1 to 30; branches 1 and 2 are dedicated as master branches, and
branches 3 to 30 are slave branches (PCM with A-Law encoding)
1 to 22; branches 1 and 2 are dedicated as master branches, and
branches 3 to 22 are slave branches (PCM with Mu-Law encoding)
1 to 32; in broadcast mode, branch 1 is dedicated as the master
branch (VCB with A-Law encoding)
1 to 24; in broadcast mode, branch 1 is dedicated as the master
branch (VCB with Mu-Law encoding)
gain
Syntax gain
Context config>scada>branch
Description This command enables the context to set gain levels for a branch.
To Next Page
Loading...
