Nokia 7705 SAR - 3.13.2.3 Adapter Card Commands

Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 315
3.13.2.3 Adapter Card Commands
mda
Syntax [no] mda mda-slot
Context config>card
Description This mandatory command enables access to a card’s MDA CLI context to configure adapter
cards.
Default n/a
Parameters mda-slot — the adapter card or module slot number to be configured
Values
ais-propagation
Syntax ais-propagation {enable | disable}
Context config>card>mda
1 to 6 on the 7705 SAR-8
1 to 12 and X1 to X4 for XMDA cards on the 7705 SAR-18
1 (for Ethernet), 2 (for T1/E1), and 3 (for
module)
on the 7705 SAR-M variants
that support modules
1 (for Ethernet) and 2 (for T1/E1) on the 7705 SAR-A
1 (for Ethernet) and 2 (for GNSS RF) on the 7705 SAR-Ax
1 (for Ethernet) on the 7705 SAR-W
1 (for Ethernet) and 2 (for DSL on the variant
that supports xDSL)
on the 7705 SAR-Wx
1 (for Ethernet), 2 (for module position 1),
and 3 (for module position 2)
on the 7705 SAR-H
1 (for Ethernet) and 2 (for RS-232) on the 7705 SAR-Hc
1 (for T1/E1); 2 (for Ethernet XOR RJ-45
ports 2/1A and 2/2A, Ethernet XOR SFP
ports 2/1B and 2/2B, Ethernet ports 2/3 to
2/6, and 10GigE SFP+ port 2/7); 3 (for
Ethernet XOR RJ-45 ports 3/1A and 3/2A,
Ethernet XOR SFP ports 3/1B and 3/2B,
Ethernet ports 3/3 to 3/6, and 10GigE SFP+
port 3/7)
on the 7705 SAR-X