Nokia 7705 SAR - 3.11.1.8 Configuring Ring Adapter Card or Module Parameters

7705 SAR Interfaces
202
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
CLI Syntax: config>card>mda#
mda-type a6-fxs
voice
companding-law {a-law | mu-law}
no shutdown
3.11.1.8 Configuring Ring Adapter Card or Module Parameters
Use the following CLI syntax to configure the adapter card or module parameters on
the 2-port 10GigE (Ethernet) Adapter card or 2-port 10GigE (Ethernet) module.
CLI Syntax: config>card>mda#
ring
[no] disable-aging
[no] disable-learning
[no] discard-unknown-source
fdb-table-high-wmark high-water-mark
no fdb-table-high-wmark
fdb-table-size table-size
no fdb-table-size
[no] mac-pinning port port-id
remote-age aging-timer
no remote-age
[no] static-mac mac ieee-address port port-id
[create]
[no] shutdown
After configuring the adapter card or module, you can use the
config>card>mda>ring>info detail command to display the information on the ring
adapter card or module.
*A:7705:Sar18>config>card>mda>ring# info detail
----------------------------------------------
no disable-aging
no disable-learning
no discard-unknown-source
no remote-age
no fdb-table-size
no fdb-table-high-wmark
no mac-pinning port 1/11/1
no mac-pinning port 1/11/2
----------------------------------------------
*A:7705:Sar18>config>card>mda>ring#