Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 349
3.13.2.8 General Port Commands
port
Syntax port {port-id | bundle-id}
no port {port-id | bundle-id}
Context config
Description This command enables access to the context to configure ports, multilink bundles, and IMA
groups. Before a port can be configured, the chassis slot must be provisioned with a valid
card type and the adapter card slot must be provisioned with a valid adapter card type. (See
the card and mda commands.)
Default n/a
Parameters port-id — specifies the physical port ID in the slot/mda/port format, or a virtual port
(v-port) on the 2-port 10GigE (Ethernet) Adapter card or 2-port 10GigE (Ethernet)
module (where port-id for the virtual port is either “v-port” or 3)
bundle-id — specifies the multilink bundle identifier
The command syntax must be configured as follows:
ddm-events
Syntax [no] ddm-events
Context config>port
Description This command enables or disables digital diagnostic monitoring (DDM) events for the port.
DDM is supported on Ethernet SFP ports, OC3 SONET SFP ports, and v-ports.
Default no ddm-events
Syntax bundle-type-slot/mda.bundle-num
bundle[-ppp]-slot/mda.bundle-num (Creates a multilink PPP bundle)
bundle-ima-slot/mda.bundle-num (Creates an IMA group)
bundle: keyword
slot: card/adapter card slot numbers
bundle-num: 1 to 32
For example:
router1>config# port bundle-1/1.1 (multilink PPP bundle)
router1>config# port bundle-ima-1/1.2 (IMA group bundle)
To Next Page
Loading...
