Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 447
3.13.2.21 Multilink Bundle and IMA Group Commands
multilink-bundle
Syntax [no] multilink-bundle
Context config>port
Description This command enables the context to configure bundle properties for this bundle port.
Default n/a
fragment-threshold
Syntax fragment-threshold fragment-threshold
no fragment-threshold
Context config>port>multilink-bundle
Description This command sets the maximum length (in bytes) of a fragment transmitted across the
specified MLPPP bundle or sets the length of a Tx frame across the specified IMA group
bundle in ATM cells.
The no form of this command resets the fragment threshold back to the default value.
Default 128
Parameters fragment-threshold — specifies the maximum fragment length in bytes (for MLPPP
bundles) or the Tx frame size (for IMA bundles)
Values 128 to 512 bytes (MLPPP)
128 bytes (IMA)
Note: Unless otherwise specified, references to multilink bundles refer to both multilink
(MLPPP) bundles and IMA groups.
To Next Page
Loading...
