7705 SAR Interfaces
510
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
3.13.2.30 Frame Relay Commands
frame-relay
Syntax frame-relay
Context config>port>tdm>ds1>channel-group
config>port>tdm>ds3
config>port>tdm>e1>channel-group
config>port>tdm>e3
config>port>serial>v35>channel-group
config>port>serial>x21>channel-group
Description This command allows access to the context to configure the frame relay LMI operational
parameters for a DS1/E1 channel group, a V.35 or X.21 SDI channel group, a DS-3/E-3 clear
channel port, or a channelized DS3.
The no form of this command removes the frame relay LMI operational parameters.
lmi-type
Syntax lmi-type {ansi | itu | none | rev1}
no lmi-type
Context config>port>tdm>ds1>channel-group>frame-relay
config>port>tdm>ds3>frame-relay
config>port>tdm>e1>channel-group>frame-relay
config>port>tdm>e3>frame-relay
config>port>serial>v35>channel-group>frame-relay
config>port>serial>x21>channel-group>frame-relay
Description This command configures the LMI type for frame relay interfaces. LMIs are sets of
enhancements to the basic frame relay specification.
Default itu
Parameters ansi — specifies ANSI T1.617 Annex D
itu — specifies ITU-T Q933 Annex A
none — disable frame relay LMI on the port/channel
rev1 — specifies Rev 1 version of ANSI T1.617 Annex D
To Next Page
Loading...
