Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 265
4. The IMA member link must exist in the specified group for the command to be
accepted.
5. The test pattern procedure must be shut down before a new test-link value or
test pattern is accepted.
6. The current IMA group test pattern configuration and result of a given IMA test
can be seen by executing a show command for the IMA group. A test-link result
can have three values:
− Disabled: the test-link is currently not running
− Operating: the test pattern procedure is no shutdown and there are
currently no failed links for this running test-pattern procedure
− Link-Failed: one or more links have failed the test-pattern procedure.
Execute a show port slot/mda/port ima-link command to see the failed link
and received pattern value.
7. Deleting a member link that is the same as the specified test-link, to stay in
compliance with key point 4, will result in the test-link value being reset to
default.
IMA test procedure configurations are not saved when the admin save
command is executed.
3.11.2.18 Configuring SDI Ports for IPCP Encapsulation
V.35 and X.21 ports on the 12-port Serial Data Interface card can be configured for
IPCP encapsulation to support PPP SAPs for Ipipes. See the 7705 SAR Services
Guide for more information about IP interworking VLL (Ipipe) services.
Use the following CLI syntax to configure IPCP parameters for V.35 serial ports. X.21
ports that are configured for super-rate speeds are also supported. The encap-type
must be set to ipcp.
CLI Syntax: port port-id
serial
v35
channel-group channel-group-id
encap-type {cem | frame-relay | ipcp
| hdlc | cisco-hdlc}
mode access
ppp
keepalive time-interval
[dropcount drop count]
exit
exit
no shutdown
exit
To Next Page
Loading...
