7705 SAR Interfaces
294
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
— [no] magic-number
— multiclass count
—no multiclass
— mrru mrru
—no mrru
— red-differential-delay red-diff-delay [down]
—no red-differential-delay
— [no] short-sequence
— yellow-differential-delay yellow-diff-delay
—no yellow-differential-delay
3.13.1.16 Serial Commands
config
— [no] port {port-id}
— serial
— [no] rs232
— [no] channel-group channel-group-id
— crc {16 | 32}
— description description-string
—no description
— encap-type cem
—no encap-type
— idle-payload-fill {all-ones | pattern pattern}
—no idle-payload-fill
— mode access
— [no] shutdown
— character-length {6 | 7 | 8}
— clock-source slave
— control-lead {input | output}
— input
— alb-cts {high | low | end-to-end}
— dtr-dsr
{high | low}
— rdl-ri {high | low}
— rts-dcd {high | low | end-to-end}
— monitor
— alb-cts {on | off}
— dtr-dsr {on | off}
— rdl-ri {on | off}
— rts-dcd {on | off}
— output
— cts-alb {high | low | end-to-end}
— dcd-rts {high | low | end-to-end}
— dsr-dtr {high | low}
— ri-rdl {high | low}
— data-position {F0-B5 |
F0-B6}
— device-gender {dte | dce}
— device-mode {synchronous | asynchronous}
— duplex {half | full}
— hold-time {[up hold-time-up] [down hold-time-down]}
—no hold-time
To Next Page
