7705 SAR Interfaces
406
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
alb-cts
Syntax alb-cts {on | off}
Context config>port>serial>rs232>control-lead>monitor
config>port>serial>v35>control-lead>monitor
Description This command enables monitoring on the Analog Loopback (ALB) or Clear To Send (CTS)
input control lead. For a DCE device, the input control lead is ALB. For a DTE device, the
input control lead is CTS.
This command is valid only for RS-232 and V.35 interfaces.
Default off
Parameters on — monitoring is enabled on the lead
off — monitoring is disabled on the lead
c-i
Syntax c-i {on | off}
Context config>port>serial>x21>control-lead>monitor
Description This command enables monitoring on the Control (C) or Indication (I) input control lead. For
a DCE device, the input control lead is C. For a DTE device, the input control lead is I.
This command is valid only for an X.21 interface.
Default off
Parameters on — monitoring is enabled on the lead
off — monitoring is disabled on the lead
dtr-dsr
Syntax dtr-dsr {on | off}
Context config>port>serial>rs232>control-lead>monitor
config>port>serial>v35>control-lead>monitor
Description This command enables monitoring on the Data Terminal Ready (DTR) or Data Set Ready
(DSR) input control lead. For a DCE device, the input control lead is DTR. For a DTE device,
the input control lead is DSR.
This command is valid only for RS-232 and V.35 interfaces.
Default off
To Next Page
Loading...
