Nokia 7705 SAR - 3.11.2.3 Configuring Ethernet Port Parameters

Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 223
The following CLI syntax shows an example of configuring a microwave link on the
7705 SAR-8; the MPR-e radios are in standalone mode.
Example: config# port mw-link-24
config>port# no shutdown
config>port# mw
config>port>mw# hold-time up 0 down 0
config>port>mw# no peer-discovery
config>port>mw# protection
config>port>mw# radio 1/2/3 main create
config>port>mw>radio# database mwLink1.tar
config>port>mw>radio# name radiomain
config>port>mw>radio# standalone
config>port>mw>radio# tx-mute
config>port>mw>radio# exit
config>port>mw# radio 1/2/3 spare create
config>port>mw>radio# database mwLink1.tar
config>port>mw>radio# name radiospare
config>port>mw>radio# standalone
config>port>mw>radio# tx-mute
config>port>mw>radio# exit
config>port>mw# revert rps eps
config>port>mw# exit
config>port# exit
3.11.2.3 Configuring Ethernet Port Parameters
Use the following CLI syntax to configure Ethernet network and access port
parameters. For more information on the dot1x command, see Configuring 802.1x
Authentication Port Parameters. For more information on the mac-auth and
mac-auth-wait commands, see Configuring MAC Authentication Port Parameters.
CLI Syntax: config# port port-id
ethernet
access
egress
unshaped-sap-cir cir-rate
autonegotiate limited
cfm-loopback priority {low | high | dot1p}
[match-vlan {vlan-range | none}]
crc-monitor
sd-threshold threshold [multiplier multiplier]
no sd-threshold
sf-threshold threshold [multiplier multiplier]
no sf-threshold
window-size seconds