Nokia 7705 SAR - 3.11.2.4 Configuring DSL Port Parameters

7705 SAR Interfaces
230
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
port-control auto
radius-plcy dot1xpolicy
re-authentication
re-auth-period 3600
max-auth-req 2
transmit-period 30
quiet-period 60
supplicant-timeout 30
server-timeout 30
mac-auth
mac-auth-wait 20
----------------------------------------------
ALU-A>config>port>ethernet>dot1x#
3.11.2.4 Configuring DSL Port Parameters
Use the following CLI syntax to configure DSL port parameters.
CLI Syntax: config# port port-id
dsl
adsl2plus {g992-5-a | g992-5-b}
atm-pvc
cfm-loopback priority {low | high}
dot1q-etype
efm-oam
accept-remote-loopback
hold-time time-value
[no] hold-time
mode {active | passive}
no shutdown
transmit-interval interval [multiplier
multiplier]
tunneling
egress-rate sub-rate
encap-type {dot1q | null | qinq}
hold-time {up hold-time-up | down hold-time-down}
lacp-tunnel
line number
no shutdown
loopback {internal} {timer {0 | 30..86400}}
mac ieee-address
mode {access | network}
mtu mtu-bytes
network
accounting-policy policy-id
[no] collect-stats
queue-policy name
qinq-etype 0x0600..0xffff
ssm