Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 267
3.11.2.19 Configuring TDM and SDI Ports for Frame Relay
Encapsulation
Frame relay service can be configured on the following ports:
• 16-port T1/E1 ASAP Adapter card, version 2, on DS1 or E1 ports
• 32-port T1/E1 ASAP Adapter card on DS1 or E1 ports
• 4-port DS3/E3 Adapter card on clear channel DS3 or E3 ports, or on DS3 ports
channelized to DS1 or E1 down to DS0
• 12-port Serial Data Interface card on V.35 and X.21 ports
Frame relay ports can be configured in access mode to support:
• Fpipes on:
− 16-port T1/E1 ASAP Adapter card, version 2, on DS1 or E1 ports
− 32-port T1/E1 ASAP Adapter card on DS1 or E1 ports
− 4-port DS3/E3 Adapter card on clear channel DS3 or E3 ports, or on DS3
ports channelized to DS1 or E1 down to DS0
− 12-port Serial Data Interface card on V.35 or X.21 ports
• Ipipes on:
− 16-port T1/E1 ASAP Adapter card, version 2, on DS1 or E1 ports
− 32-port T1/E1 ASAP Adapter card on DS1 or E1 ports
− 4-port DS3/E3 Adapter card on clear channel DS3 or E3 ports only
− 12-port Serial Data Interface card on V.35 or X.21 ports
The encap-type must be set to frame-relay. The settings for the frame relay port can
be modified by using the parameters under the frame-relay command hierarchy as
shown in the following examples. The settings apply to frame relay ports used for
Fpipe SAPs and interworking Ipipe SAPs. See the 7705 SAR Services Guide for
more information about frame relay VLL (Fpipe) services and IP interworking VLL
(Ipipe) services.
Use the following CLI syntax to configure a frame relay access port on a 16-port
T1/E1 ASAP Adapter card or a 32-port T1/E1 ASAP Adapter card.
CLI Syntax: port port-id
tdm
e1
channel-group channel-group-id
To Next Page
Loading...
