Nokia 7705 SAR - Page 453

Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 453
red-differential-delay
Syntax red-differential-delay red-diff-delay [down]
no red-differential-delay
Context config>port>multilink-bundle
Description This command sets the maximum acceptable differential delay for individual circuits within a
multilink bundle.
The no form of this command restores the red-differential-delay defaults.
Default n/a
Parameters red-diff-delay — the maximum red differential delay value, in milliseconds
Values 0 to 25 ms for MLPPP bundles
2 to 75 ms for IMA bundles on the 16-port T1/E1 ASAP Adapter card
and 32-port T1/E1 ASAP Adapter card
2 to 75 ms for IMA bundles on the 2-port OC3/STM1 Channelized
Adapter card
down — transition the circuit that exceeded the differential delay to a down state (for
example, remove it from the multilink bundle from an operational perspective). To
transition the circuit back to the up state, the user should shutdown, then no
shutdown the channel group.
short-sequence
Syntax [no] short-sequence
Context config>port>multilink-bundle
Description This command specifies that the MLPPP bundle should use short (12 bit) sequence numbers
instead of the default 24-bit sequence number. This command is only valid for MLPPP
bundles.
The no form of this command disables the short-sequence feature.
Default no short-sequence
yellow-differential-delay
Syntax yellow-differential-delay yellow-diff-delay
no yellow-differential-delay
Context config>port>multilink-bundle