7705 SAR Interfaces
454
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
Description This command sets the yellow warning threshold for the differential delay for members within
a multilink bundle. If circuit’s delay exceeds the yellow-differential delay value, a log message
and SNMP trap is sent. This command is only valid for MLPPP bundles.
The no form of this command removes the yellow-differential-delay.
Default n/a
Parameters yellow-diff-delay — the maximum yellow differential delay threshold value, in
milliseconds
Values 1 to 25
ima
Syntax ima
Context config>port>multilink-bundle
Description This command enables the context to configure parameters for an IMA group. An IMA group
is a collection of physical links bundled together and assigned to an ATM port. IMA enables
a high-speed channel that is composed of ATM cells to be transported as a number of lower-
speed circuits. They are then reassembled as the original high-speed ATM channel.
This command is only valid for IMA bundles.
link-delay
Syntax link-delay {activate | deactivate} milliseconds
no link-delay {activate | deactivate}
Context config>port>multilink-bundle>ima
Description This command specifies the time delay between detection of a link activation/deactivation
condition and acting upon it (going in/out of the Rx failure state on a link).
Parameters activate milliseconds — the time, in milliseconds, used to clear an existing LIF, LODS,
or FRI-IMA alarm. The time specified determines how long is needed for member
links to stabilize before being activated.
Values 1 to 30000 ms
Default 1000
deactivate milliseconds — the time, in milliseconds, used to raise an LIF, LODS, or FRI-
IMA alarm. The time specified determines how long before a member link is declared
in error and is deactivated.
Values 1 to 30000 ms
Default 2000
To Next Page
Loading...
