Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 455
test-pattern-procedure
Syntax test-pattern-procedure
Context config>port>multilink-bundle>ima
Description This command enables the context to configure IMA test pattern procedures. This command
and its sub-commands are not saved in the router configuration between reboots.
test-link
Syntax test-link port-id
no test-link
Context config>port>multilink-bundle>ima>test-pattern-procedure
Description This command specifies IMA members on which an IMA test pattern procedure is to be
performed.
The no form of this command deletes the link from the test-pattern procedure. The test-
pattern procedure must be shut down first.
Default no test-link
Parameters port-id — the port ID to be used to verify link connectivity within an IMA group
test-pattern
Syntax test-pattern pattern
no test-pattern
Context config>port>multilink-bundle>ima>test-pattern-procedure
Description This command specifies the transmit test pattern in an IMA group loopback operation. This
value can only be changed when the test-pattern-procedure command is shut down.
The no form of this command restores the test pattern to the default.
Default 0
Parameters pattern — specifies an integer taking the following values:
Values 0 to 255
To Next Page
Loading...
