Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 425
idle-payload-fill
Syntax idle-payload-fill {all-ones | pattern pattern}
no idle-payload-fill
Context config>port>serial>rs232>channel-group
config>port>serial>v35>channel-group
config>port>serial>x21>channel-group
Description This command defines the data pattern to be transmitted when the circuit emulation service
is not operational or temporarily experiences underrun conditions.
This command is valid only if encap-type is cem.
The no form of this command restores the default value.
Default all ones
Parameters all-ones — defines the 8-bit value to be transmitted as 11111111
pattern — defines the 8-bit value to be transmitted as a user-defined pattern (0 to 255)
mode
Syntax mode {access | network}
Context config>port>serial>rs232>channel-group
config>port>serial>v35>channel-group
config>port>serial>x21>channel-group
Description This command configures a serial port for access mode operation. Serial ports do not support
network mode; if the user selects the network option, the CLI returns an error message.
An access port or channel is used for customer-facing traffic on which services are
configured. SAPs can only be configured on an access port or channel. When a serial port is
configured for access mode, multiple services can be configured on the port.
Default access
Parameters access — configures the serial channel as service access
network — configures the serial channel for transport network use (not applicable)
To Next Page
Loading...
