7705 SAR Interfaces
424
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
encap-type
Syntax encap-type {cem | ipcp | frame-relay | hdlc | cisco-hdlc}
no encap-type
Context config>port>serial>rs232>channel-group
config>port>serial>v35>channel-group
config>port>serial>x21>channel-group
Description This command configures the encapsulation method used for the channel group.
When encap-type is specified, the channel group must be deleted before encap-type can
be changed.
The frame-relay, ipcp, hdlc, and cisco-hdlc encapsulation types are not supported on the
RS-232 interface or on ports with subrate speeds (below 64 kb/s).
The no form of this command restores the default value.
Default no encap-type
Parameters cem — specifies the encapsulation type as circuit emulation mode
frame-relay — specifies the encapsulation type as frame relay mode
ipcp — specifies the encapsulation type as ipcp mode for a PPP channel group in
access mode
hdlc — specifies the encapsulation type as hdlc mode
cisco-hdlc — specifies the encapsulation type as cisco-hdlc mode
idle-cycle-flag
Syntax idle-cycle-flag {flags | ones}
no idle-cycle-flag
Context config>port>serial>v35>channel-group
config>port>serial>x21>channel-group
Description This command defines the value to be transmitted by the channel group during its idle cycle.
The command is valid only if the encap-type is frame-relay or ipcp.
Default flags
Parameters flags — defines the 8-bit value to be transmitted as 01111110
ones — defines the 8-bit value to be transmitted as 11111111
To Next Page
Loading...
