Nokia 7705 SAR - Page 511

Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 511
mode
Syntax mode {dce | dte | bidir}
no lmi-type
Context config>port>tdm>ds1>channel-group>frame-relay
config>port>tdm>ds3>frame-relay
config>port>tdm>e1>channel-group>frame-relay
config>port>tdm>e3>frame-relay
config>port>serial>v35>channel-group>frame-relay
config>port>serial>x21>channel-group>frame-relay
Description This command sets the frame relay interface to the DCE, DTE, or bidirectional mode of LMI
operation. The DTE mode causes the router to send status enquiries over the interface. The
DCE mode causes the router to respond to status enquiries. In bidirectional mode, the router
performs both DTE and DCE operation over the FR interface. The bidirectional mode applies
to the ANSI and ITU LMI types only.
This feature is used when two routers are connected back-to-back, running frame relay
encapsulation.
Default dce
Parameters dce — specifies the DCE mode
dte — specifies the DTE mode
bidir — the bidirectional mode for LMI types ANSI and ITU
n391dte
Syntax n391dte intervals
no n391dte
Context config>port>tdm>ds1>channel-group>frame-relay
config>port>tdm>ds3>frame-relay
config>port>tdm>e1>channel-group>frame-relay
config>port>tdm>e3>frame-relay
config>port>serial>v35>channel-group>frame-relay
config>port>serial>x21>channel-group>frame-relay
Description This command configures the DTE full status polling interval for the frame relay LMI. The
number specifies the frequency at which inquiries expect a full status report.
The no form of this command returns the n391dte counter to the default value.
Default 6