7705 SAR Interfaces
348
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
rdi — suppresses RDI faults
all — suppresses all faults
tx-mute
Syntax [no] tx-mute
Context config>port>mw>radio
Description This command mutes the transmitter on the radio MPR-e radio.
The no form of this command disables the mute configuration.
revert
Syntax [no] revert [eps] [rps]
Context config>port>mw
Description This command configures the type of revertive switching on the microwave link. Revertive
switching occurs when the MPR-e radio operation switches from the spare radio back to the
main radio after a fault condition is cleared.
The no form of this command removes the revertive switching configuration.
Default n/a
Parameters eps — sets Equipment Protection Switching as the revertive switching type
rps — sets Radio Protection Switching as the revertive switching type
Note: If EPS is configured as the revertive switching type, Transmission Protection
Switching (TPS) is automatically applied as well; TPS cannot be enabled independently.
To Next Page
Loading...
