Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 347
rsl-history
Syntax rsl-history file-url
no rsl-history
Context config>port>mw>radio
Description This command enables the RSL history file for an MPR-e radio to be uploaded to the
7705 SAR.
The no form of this command removes the configuration.
Default no rsl-history
Parameters file-url — specifies the URL of the RSL history file for the specified radio
Values local-url:[cflash-id/][file-path]; 99 characters maximum
standalone
Syntax [no] standalone
Context config>port>mw>radio
Description This command configures the MPR-e radio to operate in standalone mode.
The no form of this command removes the standalone designation and sets the MPR-e radio
in MWA mode.
Default no standalone
suppress-faults
Syntax suppress-faults [hber] [rsl-threshold] [rdi] [all]
[no] suppress-faults
Context config>port>mw>radio
Description This command suppresses detected faults on microwave links. If microwave link faults are
detected, an event is logged and the link is disabled. When faults are suppressed, the event
is still logged, but the microwave link is not disabled. By default, the system does not
suppress faults for FFD.
The no form of this command removes fault suppression.
Default no suppress-faults
Parameters hber — suppresses High Bit Error Rate faults
rsl-threshold — suppresses RSL threshold crossing faults
To Next Page
Loading...
